Owners Manual

Figure 43. Removing the server board
1 Install the server board.
2 Complete the procedure listed in After working inside your system.
Installing server board
1 Follow the safety guidelines listed in the Safety instructions section.
2 Complete the procedure listed in Before working inside your system.
1 Remove the new server board from its antistatic bag and hold by the edges.
2 If removed, install the Trusted Platform Module (TPM). For information about how to install the TPM, see the Installing trusted
platform module section. For more information about the TPM, see the Trusted platform module section.
NOTE
: The TPM plug-in module once installed is attached to the server board and cannot be removed. In the event of a
server board replacement, a TPM plug-in module is provided along with the server board for all systems that have a TPM.
3 Align the I/O ports on the server board with the front of the server.
4 Angle the server board into the I/O ports. Make sure the ports on the server board are seated correctly in the chassis.
5 Gently lower the server board in the chassis.
6 After the server board is in place, slide it towards the grill until the server board is seated in place and the screw holes (server board
and chassis) are aligned.
88
Installing and removing server components