Owners Manual

Table 43. Assembly material

Description Quantity Torque (lbs/inch)

M3 screw 4 (1 per HDD) 6 ± 0.2

3 Align the HDD assembly in the chassis.

4 Install the HDD assembly and slide it to seat properly.

5 Secure with the thumb screw.

Figure 31. Installing the 2.5-inch HDD assembly

Next step

1 Complete the procedure listed in After working inside your system.

Removing 3.5-inch hard drive from the rear bay

Prerequisites

NOTE

: The procedure is available only for DSS 9620 server with 3.5-inch HDD.

1 Follow the safety guidelines listed in the Safety instructions section.

2 Complete the procedure listed in Before working inside your system.

CAUTION

: To maintain proper system cooling, all empty hard drive slots must have hard drive blanks installed.

Steps

1 Pull up the plunger and slide the HDD assembly to release from the HDD tray.

Installing and removing server components