Manualshelf

Users Guide

ManualsBrandsDell ManualsConverged InfrastructureDSS 9620
331332333334335336337338339340
● diag — Embedded Diagnostics
● drvpack — Embedded OS Driver Pack
● lcdata — Clear the Lifecycle Controller Data
● idrac — iDRAC reset to default
● overwritepd — Overwrite hard drives that do not support Instant Secure Erase (ISE)
● percnvcache — Reset controller cache
● vflash — Reset vFLASH
● secureerasepd — Erase Hard Drives, SSDs, and NVMes that support ISE
● allapps — Clears all OS applications
NOTE: If SEKM is enabled on the server, then disable SEKM using the racadm sekm disable command before using
this command. This can avoid any storage devices being locked out which are secured by iDRAC, if SEKM settings are
erased from iDRAC by executing this command.
For more information, see the iDRAC RACADM CLI Guide available at https://www.dell.com/idracmanuals.
NOTE: The Dell tech center link appears on the iDRAC GUI on Dell branded systems. If you erase system data by using
WSMan command and want the link to appear again, reboot the host manually and wait for CSIOR to run.
NOTE: After you run System Erase, the VDs may still appear. Run CSIOR after System Erase is completed and iDRAC is
rebooted.
Resetting iDRAC to factory default settings
You can reset iDRAC to the factory default settings using the iDRAC Settings utility or the iDRAC Web interface.
Resetting iDRAC to factory default settings using iDRAC web
interface
To reset iDRAC to factory default settings using the iDRAC Web interface:
1. Go to Maintenance > Diagnostics.
The Diagnostics Console page is displayed.
2. Click Reset iDRAC to Default Settings.
The completion status is displayed in percentage. iDRAC reboots and is restored to factory defaults. The iDRAC IP is reset
and is not accessible. You can configure the IP using the front panel or BIOS.
Resetting iDRAC to factory default settings using iDRAC settings
utility
To reset iDRAC to factory default values using the iDRAC Settings utility:
1. Go to Reset iDRAC configurations to defaults.
The iDRAC Settings Reset iDRAC configurations to defaults page is displayed.
2. Click Yes.
iDRAC reset starts.
3. Click Back and navigate to the same Reset iDRAC configurations to defaults page to view the success message.
Troubleshooting managed system using iDRAC
337