Operating Manual

FCC Radio Frequency (RF) Exposure Information

This device has been evaluated to, and shown to be compliant with, the FCC Radio Frequency

(RF) exposure limits.

Devices such as Desktop computers and Access Points (AP) that contain wireless functions (such

as 802.11, Bluetooth, 3G or 4G) must be installed to provide a separation distance of at least

20cm from people to ensure compliance with the RF exposure requirements.

Certain laptop/notebook computers, with antennas located toward the top of the screen, may

require a separation distance of at least 20cm between the antennas and persons when they are

operating to ensure compliance with the RF exposure requirements. These laptop/notebook

computers are designed such that, during normal use with the screen open, the antenna-to-user

distance is greater than 20cm.

Some devices may have additional requirements for operating conditions to ensure compliance

with RF exposure requirements. Specific instructions, where required, will be contained in the

manual for that device. Please read your operating manual carefully.

Interference Statement

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the manufacturer's instruction manual, may cause interference with

radio and television reception. This equipment has been tested and found to comply with the

limits for a Class B digital device pursuant to Part 15 of the FCC Rules.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause

undesired operation.

Notice: The FCC regulations provide that changes or modifications not expressly approved by

Dell Inc. could void your authority to operate this equipment.

These limits are designed to provide reasonable protection against harmful interference in a

residential installation. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference with radio or television

reception, which can be determined by turning the equipment off and on, you are encouraged to

try to correct the interference by one or more of the following measures:

• Reorient the receiving antenna.

• Relocate the system with respect to the receiver.

PAGE 1
FCC Radio Frequency (RF) Exposure Information This device has been evaluated to, and shown to be compliant with, the FCC Radio Frequency (RF) exposure limits. Devices such as Desktop computers and Access Points (AP) that contain wireless functions (such as 802.11, Bluetooth, 3G or 4G) must be installed to provide a separation distance of at least 20cm from people to ensure compliance with the RF exposure requirements.
PAGE 2
• Move the system away from the receiver. • Plug the system into a different outlet so that the system and the receiver are on different branch circuits. If necessary, consult a representative of Dell Inc. or an experienced radio/television technician for additional suggestions. NOTE: Any additional Wireless module must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that comes with the product.