User's Manual

OEM Installation Guidance

Dell RFID 13.56MHz Wireless Module

FCC ID: E2K-DWRFID2001

IC: 1514B-DWRFID2001

- OEM integrators must ensure that its product is electrically identical to Dell’s

reference designs. Any modifications to Dell’s reference designs may invalidate

regulatory approvals in relation to the product, or may necessitate notifications to

the relevant regulatory authorities.

- OEM integrators are responsible for regression testing to accommodate changes to

designs, new antennas, and host and submit for C2PC filings.

Colocation with other transmitter modules will be addressed through filings for those

co-located transmitters when necessary or that colocation of other transmitters will

be according to applicable KDB guidelines including those for RF exposure

-The final system integrator must ensure there is no instruction provided in the user

manual or customer documentation indicating how to install or remove the

transmitter

- Appropriate labels must be affixed to the product that complies with applicable

regulations in all respects. The regulatory label on the final system must include the

statement: “Contains FCC ID: E2K-DWRFID2001 and/or IC: 1514B-DWRFID2001”.

- A user’s manual or instruction manual must be included with the product that

contains the text as required by applicable law shall be provided to OEM integrators.

They may include:

Federal Communication Commission Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

PAGE 1
OEM Installation Guidance Dell RFID 13.56MHz Wireless Module FCC ID: E2K-DWRFID2001 IC: 1514B-DWRFID2001 - OEM integrators must ensure that its product is electrically identical to Dell’s reference designs. Any modifications to Dell’s reference designs may invalidate regulatory approvals in relation to the product, or may necessitate notifications to the relevant regulatory authorities.
PAGE 2
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
PAGE 3
Industry Canada statement This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.