Owners Manual
Table Of Contents
- About Your System
- Accessing System Features During Startup
- Front-Panel Features and Indicators
- LCD Panel Features
- Hard-Drive Indicator Patterns for RAID
- Back Panel Features and Indicators
- Power Indicator Codes
- NIC Indicator Codes
- LCD Status Messages
- System Messages
- Warning Messages
- Diagnostics Messages
- Alert Messages
- Other Information You May Need
- Using the System Setup Program and UEFI Boot Manager
- Installing System Components
- Recommended Tools
- Inside the System
- Front Bezel (Optional)
- Information Tag
- Opening and Closing the System
- Hard Drives
- Power Supplies
- Internal SD Module
- Internal SD Flash Card
- Internal USB Memory Key
- Internal USB Cable
- Integrated Dell Remote Access Controller 6 (iDRAC6) Enterprise Card (Optional)
- VFlash Media (Optional)
- NIC Hardware Key
- Cooling Shroud
- Cooling Fans
- Optical Drive
- Integrated Storage Controller Card
- RAID Battery
- Cable Routing
- Expansion Cards and Expansion-Card Risers
- Expansion Card Installation Guidelines
- Installing an Expansion Card
- Removing an Expansion Card
- Removing Expansion-Card Riser 1
- Replacing Expansion-Card Riser 1
- Removing Expansion-Card Riser 2
- Replacing Expansion-Card Riser 2
- Removing Expansion-Card Riser 2 From the Expansion-Card Bracket
- Replacing the Riser 2 Board on the Expansion-Card Bracket
- System Memory
- Processors
- System Battery
- Control Panel Assembly
- SAS Backplane (Service Only Procedure)
- System Board
- Troubleshooting Your System
- Safety First-For You and Your System
- Troubleshooting System Startup Failure
- Troubleshooting External Connections
- Troubleshooting the Video Subsystem
- Troubleshooting a USB Device
- Troubleshooting a Serial I/O Device
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting a Fan
- Troubleshooting System Memory
- Troubleshooting an Internal SD Card
- Troubleshooting an Internal USB Memory Key
- Troubleshooting an Optical Drive
- Troubleshooting a Hard Drive
- Troubleshooting a Storage Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Processor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Index
144 Installing System Components
Figure 3-28. Replacing the System Battery
7
To install a new system battery, support the battery connector by pressing
down firmly on the positive side of the connector.
8
Hold the battery with the “+” facing up and slide it under the securing
tabs at the positive side of the connector.
9
Press the battery straight down into the connector until it snaps into place.
10
Replace the fan bracket. See "Replacing the Fan Bracket" on page 108.
11
Close the system. See "Closing the System" on page 83.
12
Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
13
Enter the System Setup program to confirm that the battery is operating
properly. See "Entering the System Setup Program" on page 58.
14
Enter the correct time and date in the System Setup program's
Time
and
Date
fields, and re-enter any customized option settings as needed.
15
Exit the System Setup program.
1 positive side of battery connector 2 system battery
3 negative side of battery connector
2
3
1