Owners Manual

Table Of Contents
Installing System Components 149
8
When the backplane cannot slide upward any farther, pull the backplane
toward the back of the system to remove it from the retention hooks.
9
Lift the board out of the system, being careful to avoid damaging
components on the face of the board.
10
Place the SAS backplane face down on a work surface.
Figure 3-30. Removing and Installing a SAS Backplane
1 drive bays 2 SAS backplane board
3 power cable from system board 4 SAS A cable
5 SAS B cable 6 securing slots (8)
7 securing tabs (7) 8 SAS backplane board release tab
1
7
4
8
3
2
5
6