Laptop User Manual
Back to Contents Page  
 Keyboard  
Dell™Latitude™E6400andE6400ATGand 
MobileWorkstationPrecision™M2400ServiceManual 
Removing the Keyboard  
Replacing the Keyboard  
Removing the Keyboard  
 
 
1. Follow the procedures in Before Working on Your Computer.  
 
2. Remove the LED cover (see Removing the LED Cover).  
 
3. Remove the two M2 x 3-mm screws along the top of the keyboard.  
 
4. Using the pull tab, gently lift the top of the keyboard, then pull back to disconnect the keyboard.  
Replacing the Keyboard  
 
 
1. Holding the top of the keyboard slightly above the computer, slide the bottom of the keyboard in at an angle, and fit the tabs and keyboard connector 
along the bottom of the keyboard beneath the front-inside edge of the palm rest.  
 
2. Carefully press each side to snap the keyboard into place.  
 
3. Replace the two M2 x 3-mm screws at the top of the keyboard.  
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: The key caps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Exercise care when removing and handling the 
keyboard.
1 
M2 x 3-mm screws (2) 
2 
keyboard 
3 
pull tab 
 
 
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: The key caps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Exercise care when removing and handling the 
keyboard.










