User Manual
Table Of Contents
- Dell Latitude E7470 Owner's Manual
- Working on your computer
- Removing and installing components
- Recommended tools
- Subscriber Identification Module (SIM) card
- SD card
- Base cover
- Battery
- Solid State Drive (SSD)
- PCIe Solid State Drive (SSD)
- Speaker
- Coin cell battery
- WWAN card
- WLAN card
- Memory module
- Heat sink
- Power connector port
- Dock frame
- System board
- Keyboard
- Display assembly
- Display bezel
- Display panel
- Display hinges
- eDP cable
- Camera
- Palmrest
- System Setup
- Boot Sequence
- Navigation keys
- System setup options
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- System and setup password
- Diagnostics
- Specifications
- Contacting Dell
NOTE: You may need a plastic scribe to lift the base cover from the edges.
Installing the base cover
1 Align the tabs on the base cover with the slots on the computer.
2 Press the edges of the cover until it clicks into place.
3 Tighten the screws to secure the base cover to the computer.
4 Follow the procedure in After working inside your computer.
Battery
Removing the battery
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 To remove the battery:
a Disconnect the battery cable from the connector on the system board [1].
b Remove the screw that secures the battery to the computer [2].
c Lift the battery away from the computer [3].
10
Removing and installing components