User Manual
Table Of Contents
- Dell Latitude E7470 Owner's Manual
- Working on your computer
- Removing and installing components
- Recommended tools
- Subscriber Identification Module (SIM) card
- SD card
- Base cover
- Battery
- Solid State Drive (SSD)
- PCIe Solid State Drive (SSD)
- Speaker
- Coin cell battery
- WWAN card
- WLAN card
- Memory module
- Heat sink
- Power connector port
- Dock frame
- System board
- Keyboard
- Display assembly
- Display bezel
- Display panel
- Display hinges
- eDP cable
- Camera
- Palmrest
- System Setup
- Boot Sequence
- Navigation keys
- System setup options
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- System and setup password
- Diagnostics
- Specifications
- Contacting Dell
5 To remove the heat sink:
a Remove the screws that secure the heat sink assembly to the system board [1, 2, 3, 4].
NOTE
: Remove the screws that secure the heat sink to the system board in the order of the callouts shown [1, 2, 3, 4].
b Lift the heat sink assembly from the system board [5].
Installing the heat sink assembly
1 Align the heat sink assembly with screw holders on the system board.
2 Tighten the screws to secure the heat sink assembly to the computer and system board.
NOTE
: Tighten the screws on the system board in the order of the callout numbers [1, 2, 3, 4].
Removing and installing components 19