User Manual
Table Of Contents
- Dell Latitude E7470 Owner's Manual
- Working on your computer
- Removing and installing components
- Recommended tools
- Subscriber Identification Module (SIM) card
- SD card
- Base cover
- Battery
- Solid State Drive (SSD)
- PCIe Solid State Drive (SSD)
- Speaker
- Coin cell battery
- WWAN card
- WLAN card
- Memory module
- Heat sink
- Power connector port
- Dock frame
- System board
- Keyboard
- Display assembly
- Display bezel
- Display panel
- Display hinges
- eDP cable
- Camera
- Palmrest
- System Setup
- Boot Sequence
- Navigation keys
- System setup options
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- System and setup password
- Diagnostics
- Specifications
- Contacting Dell
Installing the display assembly
1 Insert the display hinges into the slots on the computer.
NOTE: This should be done with the display assembly in open position. Ensure that the cables are free from the hinge slots
and computer.
2
Close the display assembly.
3 Insert the WLAN and WWAN cables through the slot on the computer
4 Route the display assembly cable through the slot and routing clips on the computer.
5 Tighten the screws to secure the display assembly to the computer.
6 Route the WLAN and WWAN cables through the routing channel on the system board.
7 Connect the WLAN and WWAN cables to the connectors on the WLAN and WWAN cards.
8 Connect the display cable to the connector on the system board.
9 Place the display cable bracket over the connector and tighten the screws to secure the display cable to the system board.
10 Tighten the screws to secure the display assembly to the computer.
11 Install the display hinge brackets and tighten the screws to secure it to the computer.
12 Install the:
a WLAN card
b WWAN card
c battery
d base cover
13 Follow the procedure in After working inside your computer.
Display bezel
Removing the display bezel
NOTE
: The display bezel is available only for non touch systems.
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a base cover
b battery
c display assembly
3 Using a plastic scribe, release the tabs on the edges to release the display bezel from the display assembly [1, 2].
4 Remove the display bezel from the display assembly.
28
Removing and installing components