Users Guide

With an internet connection
1. Connect and login to the Edge Gateway.
NOTE: Connect and login to the Edge Gateway with one these options:
• Remote system configuration (only for Edge Gateway 3001 and 3002)
2. Check the current BIOS details.
$sudo uefi-fw-tools.fwupdmgr get-devices
3. Check if the update is available from LVFS service.
$sudo uefi-fw-tools.fwupdmgr refresh
4. Download the BIOS from the www.dell.com/support.
$sudo uefi-fw-tools.fwupdmgr get-updates
5. Apply the update.
$sudo uefi-fw-tools.fwupdmgr update -v
6. Restart the system.
$ sudo reboot
Dell Command | Configure (DCC)
Use DCC to update and configure the BIOS settings.
For more information on how to use DCC, see the DCC Installation Guide and User's Guide at www.dell.com/
dellclientcommandsuitemanuals.
For more information about BIOS settings on the Edge Gateway, see Default BIOS settings.
Edge Device Manager (EDM)
BIOS can be updated remotely through the EDM console connected to a remote system.
For more information about EDM, see www.dell.com/support/home/us/en/19/product-support/product/wyse-cloud-client-manager/
research.
Default BIOS settings
System configuration (BIOS level 1)
Table 21. System configuration (BIOS level 1)
BIOS level 2 BIOS level 3 Item Default value
Integrated NIC Integrated NIC Enable UEFI Network Stack
[Enable/Disable]
Enabled
[Disabled, Enabled, Enabled w/
PXE]
Enabled w/PXE
Serial Port1 [Disable, RS232, RS-485 HALF
DUPLEX, RS-485/422 FULL
DUPLEX]
RS232
Serial Port2 [Disable, RS232, RS-485 HALF
DUPLEX, RS-485/422 FULL
DUPLEX]
RS232
USB Configuration USB Configuration Enable Boot Support [Enable/
Disable]
Enabled
Enable USB 3.0 Controller
[Enable/Disable]
Enabled
68