Service Manual

6
Replacing the antenna-cable bracket
WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway and follow
the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the steps in After working
inside your Edge Gateway.
Procedure
1. Route the ZigBee cable through the antenna-cable bracket.
2. Align the screw hole on the antenna-cable bracket with the screw hole on the system board.
3. Replace the screw (M2x4) that secures antenna-cable bracket to the system board.
4. Replace the two screws (M3x10) that secure the antenna-cable bracket to the system board.
5. Insert the antenna cables through the slots on the system base.
6. Route the antenna cables through the routing guides on the antenna bracket.
7. Replace the washers that secure the antennas to the system base.
8. Replace the nuts that secure the antennas to the system base.
Post-requisites
Replace the front cover.
17