Service Manual

Removing the WWAN bracket

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway and follow

the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the steps in After working

inside your Edge Gateway.

Prerequisites

NOTE: Depending on the configuration ordered, the WWAN card and bracket may not be available.

1. Remove the front cover.

2. Remove the antenna-cable bracket.

3. Remove the coin-cell battery.

4. Remove the right-I/O cover.

5. Remove the right-I/O bracket.

6. Remove the left-I/O bracket.

7. Remove the WWAN card.

Procedure

1. Remove the screw (M2x4) that secures the WWAN bracket to the system board.

2. Lift the WWAN bracket off the system board.