Service Manual

Removing the left-rubber gasket

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway and follow

the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the steps in After working

inside your Edge Gateway.

Prerequisites

1. Remove the front cover.

2. Remove the antenna-cable bracket.

3. Remove the coin-cell battery.

4. Remove the left-I/O bracket.

5. Remove the status-light lens.

Procedure

1. Slide the left-I/O cover from the system base.

2. Gently release the ports on the system board from the slots on the left-rubber gasket.

3. Slide and lift the left-rubber gasket off the system board.