Service Manual

Removing the WLAN bracket

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway and follow

the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the steps in After working

inside your Edge Gateway.

Prerequisites

1. Remove the front cover.

2. Remove the antenna-cable bracket.

3. Remove the coin-cell battery.

4. Remove the right-I/O cover.

5. Remove the right-I/O bracket.

6. Remove the left-I/O bracket.

Procedure

1. Slide the left-I/O cover from the system base.

2. Lift the system board off the system base.