Service Manual

Replacing the loop-back cable

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway and follow

the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the steps in After working

inside your Edge Gateway.

Procedure

1. Connect the loop-back cable to the system board.

2. Place the WLAN bracket on the system board.

3. Turn the system board over.

4. Connect the loop-back cable to the system board.

5. Align and place the system board on the system base.

6. Slide the left-I/O cover to the system base.

Post-requisites

1. Replace the left-I/O bracket.

2. Replace the right-I/O bracket.

3. Replace the right-I/O cover.

4. Replace the coin-cell battery.

5. Replace the antenna-cable bracket.

6. Replace the front cover.