Service Manual

Appendix

Connecting to the Edge Gateway

Windows 10 IoT Enterprise LTSB 2016

Boot up and login – Direct system configuration

1. Connect a monitor, keyboard and mouse to the Edge Gateway before you login.

2. Power on the Edge Gateway. At the first boot, you will not be prompted to enter login credentials. Subsequent boots will prompt for

you to log in.

NOTE: The default user name and password are both admin.

Boot up and login – Remote system configuration

NOTE: Your computer must be on the same subnet as the Edge Gateway.

1. Connect a network cable from Ethernet port one on the Edge Gateway to a DHCP-enabled network or router that provides IP

addresses.

NOTE: The first-time boot to Windows takes about 5 minutes for system configuration. Subsequent boot-ups take about 50

seconds.

2. Using the MAC address provided on the front cover of the Edge Gateway, obtain the IP address through your network’s DHCP server

or through a network analyzer.

3. On the Windows computer, search for Remote Desktop Connection and launch the application.

4. Log in using the IP address.

NOTE: Ignore any certification errors when connecting to your Edge Gateway.

Boot up and login—Static IP system configuration

NOTE: To help set up the Edge Gateway remotely, the static IP address of on the Edge Gateway is set to these values at the factory:

• IP address: 192.168.2.1

• Subnet mask: 255.255.255.0

• DHCP server: Not applicable

You can connect your Edge Gateway to a Windows computer that is on the same subnet using a crossover cable.

1. On the Windows computer, search for View network connections in the control panel.

2. In the list of network devices displayed, right-click the Ethernet adaptor that you want to use to connect to the Edge Gateway, then

click

Properties.

3. On the Networking tab, click Internet Protocol Version 4 (TCP/IPv4) → Properties.

4. Select Use the following IP address, then enter 192.168.2.x (where x represents the last digit of the IP address, for example,

192.168.2.2).

NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between 192.168.2.2 to

192.168.2.254.

5. Enter the subnet mask 255.255.255.0 , then click OK.