Users Guide

NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between 192.168.2.2 to

192.168.2.254.

5. Enter the subnet mask 255.255.255.0 , then click OK.

6. Secure a crossover network cable between Ethernet port two on the Edge Gateway and the configured Ethernet port on the

computer.

7. On the Windows computer, launch Remote Desktop Connection.

8. Connect to the Edge Gateway using the IP address 192.168.2.1. The default username and password are both admin.

Restoring Windows 10 IoT Enterprise LTSB 2016

CAUTION: These steps will delete all the data on your Edge Gateway.

You can restore Windows 10 IoT Enterprise LTSB 2016 by using a USB flash drive.

Prerequisites

Create the recovery USB flash drive. For more information, see Creating the recovery USB flash drive.

Procedure

1. Connect the recovery USB flash drive to the Edge Gateway.

2. Power on the Edge Gateway.

The Edge Gateway will automatically boot from the USB recovery flash drive and restore Windows back to the factory image.

Restoration takes about 25 minutes to complete and a confirmation log file is stored on the USB flash drive. Once restoration is

complete, the system will power off.

NOTE: The confirmation log file is named

<date>

<time>

.txt

Windows 10 IOT Enterprise LTSB 2016 basic functions

BIOS update

For more information about updating the BIOS, see Accessing and updating the BIOS.

Watchdog Timer

The Watchdog Timer for Windows 10 IoT Enterprise LTSB 2016 is controlled through the BIOS setting.

The Watchdog Timer is enabled and disabled under the BIOS setting Watchdog Timer.

NOTE: For more information about BIOS settings on the Edge Gateway, see Default BIOS settings.

Cloud LED

NOTE: To utilize the Cloud LED, download the necessary tools and drivers from www.dell.com/support.

One unique feature of the Edge Gateway 3000 Series is the

Cloud LED

. Cloud LED enables you to visually inspect the operational status of

the Edge Gateway by looking at the display light on the left panel of the Edge Gateway.

To enable this feature, you must expose and program a GPIO register on the Edge Gateway.

Follow these steps to control the Cloud LED on the Edge Gateway:

1. Download the Cloud LED utility from www.dell.com/support.

2. Extract the following files:

a. DCSTL64.dll

b. DCSTL64.sys

c. DCSTL64.inf

d. DCSTL64.cat

e. CloudLED.exe

NOTE: These files must be in the same directory.