Service Manual

Removing the back cover

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Procedure

Procedure

1. Remove the screws that secure the back cover to the chassis.

1. M3x8 screws (4) 2. M3x5 countersunk screws (5)

3. rubber feet (4) 4. back cover

5. chassis

2. Open the back cover from the chassis.

3. Disconnect the SATA-power and SATA-data cable from the hard drive or solid-state drive assembly.

OPOMBA

Disconnect the cables from the second drive if installed.

4. Remove the cables from the routing guides on the top cover.

14 Removing the back cover