Service Manual

Removing the WWAN-antenna connectors

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

Procedure

1. Remove the nuts and washers that secure the WWAN-antenna connectors one and two to the chassis.

2. Push the WWAN-antenna connectors through the chassis.

a. chassis

b. WWAN-antenna connector two

c. WWAN-antenna connector one

3. Disconnect the antenna cables from the WWAN card.

4. Remove the WWAN-antenna cables from the WWAN-cable routing guides on the chassis.

5. Remove the WLAN-antenna cable off the chassis.

Removing the WWAN-antenna connectors 43