Service Manual

Removing the CANbus card

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

Procedure

OPOMBA

Embedded Box PC is shipped with a combination of WWAN, WLAN, or CANbus card depending on the

configuration ordered.

1. Disconnect the CANbus cable from the connector on the CANbus card.

2. Remove the screws that secure the CANbus card to the system board.

3. Slide and remove the CANbus card from the mPCIE1 slot.

56 Removing the CANbus card