Service Manual

Replacing the CANbus card

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Procedure

• Post-requisites

Procedure

1. Align the notch on the CANbus card with the tab on the mPCIE1 slot.

2. Insert the CANbus card at an angle into the mPCIE1 slot.

3. Align the screw holes on the CANbus card with the screw holes on the system board.

4. Replace the screws that secure the CANbus card to the system board.

5. Connect the CANbus cable to the connector on the CANbus card.

mPCIE1 slot 2. tab

3. notch 4. M2x3 screws (2)

5. system board 6. CANbus card

7. CANbus-card cable

58 Replacing the CANbus card