Service Manual

Removing the intrusion switch

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

Procedure

1. Disconnect the intrusion-switch cable from intrusion-switch connector on the system board.

2. Remove the intrusion-switch cable from the routing guides on the chassis.

3. Slide the cable out from under the heat sink pipe.

4. Remove the screw that secures the intrusion switch to the chassis.

5. Remove the intrusion switch from the chassis.

intrusion switch 2. M3x5 countersunk screw

3. routing guide 4. intrusion-switch cable

Removing the intrusion switch 63