Service Manual

Replacing the serial ports
OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded
Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box
PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Teme:
• Procedure
• Post-requisites
Procedure
1. Connect the serial-port cable to the connector on the system board.
2. Insert the serial ports into the respective slots on the bottom cover.
OPOMBA
Match the port number with the number on the cable.
3. Replace the hexagonal screws that secure the serial ports to the bottom-cover.
Post-requisites
1. Replace the PCI/PCIe card (if necessary).
2. Follow step 2 to step 8 in “Replacing the back cover”.
38
Replacing the serial ports 67