Service Manual

Replacing the power connectors

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Procedure

• Post-requisites

Procedure

1. Insert the power cables along with the barrel connector through the slot on the chassis.

2. Replace the screws that secure the power connector to the chassis.

3. Route the power cable through the routing guide on the system board.

4. Connect the power cable to the system board.

5. Replace the screw that secures the grounding cable to the system board.

6. Insert the barrel connector through the chassis.

7. Replace the nut and washer that secure the barrel connector to the chassis.

Post-requisites

1. Replace the heat sink.

2. Replace the PCI/PCIe card (if necessary).

3. Follow step 2 to step 8 in “Replacing the back cover”.

Replacing the power connectors 79