Service Manual

Replacing the power switch

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Procedure

• Post-requisites

Procedure

1. Route the power switch and power-switch cable thought the slot on the top cover.

2. Push the power switch in to the slot and snap the power switch in place.

Post-requisites

1. Replace the top cover.

2. Replace the power connectors.

3. Replace the riser card.

4. Replace the CANbus cable.

5. Replace the PCI/PCIe card (if necessary).

6. Follow step 2 to step 8 in “Replacing the back cover”.

84 Replacing the power switch