Service Manual

Removing the CPU board

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

3. Remove the memory module.

4. Remove the heat sink.

Procedure

OPOMBA

When removing the CPU board, take note of the existing DIP switch settings and ensure that the same DIP

switch settings are applied to the new CPU board. For more information, see DIP switch settings.

1. Remove the screws that secure the CPU board to the system board.

2. Lift the CPU board off the system board.

a. M2.5x6 screws (2)

b. STDF(L5) HEX, M2.5x4 screws (3)

c. CPU board

Removing the CPU board 85