Users Guide

2. Click Change Bluetooth settings from the search result.
The Bluetooth Settings dialog box appears.
DW5580 network configuration
Follow the Service Manual to install and configure the DW5580 module and the corresponding carrier SIM card for the system. Once the
module and the SIM card are installed, follow these steps to connect and disconnect from WWAN.
1. Click Start and type Network in the search box.
2. Click Network and Sharing Center from the search result.
The Network and Sharing Center window appears.
3. From the left panel, click Change adapter settings.
4. Locate the required WWAN connection.
5. Right-click the WWAN connection, and then select Connect or Disconnect to connect to or disconnect from the WWAN adapter,
respectively.
Common port mappings on Embedded Box PC 5000 with Windows 7
Professional for Embedded Systems
Serial port mapping
The following table shows the serial port mapping at the bottom of the Embedded Box PC 5000 with Windows 7 Professional for
Embedded Systems OS image.
Table 2. Serial port mapping
Number Port type Connector Device node
1 RS232/422/485 DB9 COM1
2 RS232/422/485 DB9 COM2
3 RS232/422/485 DB9 COM3
4 RS232/422/485 DB9 COM4
Embedded Box PC 5000 GPIO module In/Out mapping
The GPIOs ports on the Embedded Box PC and Nuvoton NCT6793D uses index/data pair of CPU I/O addresses 2Eh/2Fh to access
NCT6793D.
GPIO 8 Out pin# to NCT6793D pin# map:
0 to 121 (GP00)
1 to 122 (GP01)
2 to 123 (GP02)
3 to 2 (GP03)
4 to 3 (GP04)
5 to 4 (GP05)
6 to 5 (GP06)
7 to 6 (GP07)
8 is GND
GPIO 8 In pin# to NCT6793D pin# map:
0 to 50 (GP60)
1 to 49 (GP61)
2 to 48 (GP62)
3 to 47 (GP63)
4 to 45 (GP64)
5 to 44 (GP65)
Setting up your operating system
25