Users Guide

48. Full-height FC dual port............................................................................................................................ 51
49. Half-height FC single port.........................................................................................................................51
50. Half-height SAS dual port......................................................................................................................... 52
51. IP address selection................................................................................................................................. 53
52. Open I/O station seen from the left..........................................................................................................55
53. Magazine pulled out..................................................................................................................................55
54. Management GUI main screen................................................................................................................. 60
55. Operator Panel main screen..................................................................................................................... 62
56. Front panel LEDs....................................................................................................................................... 63
57. Internal view of the library..................................................................................................................... 115
58. Drive bay covers......................................................................................................................................117
59. Alignment rails........................................................................................................................................ 117
60. Installing a tape drive............................................................................................................................. 118
61. Unlocking the drive................................................................................................................................. 118
62. Interconnect cables................................................................................................................................122
63. Unlocking or disengaging the alignment lever.......................................................................................123
64. Loosening the thumbscrews.................................................................................................................. 124
65. Sliding the module out of the rack......................................................................................................... 124
66. Power supplies........................................................................................................................................126
67. Sliding in the new power supply.............................................................................................................127
68. Controller card components...................................................................................................................129
69. Installing a Controller card.....................................................................................................................130
70. Magazine release levers......................................................................................................................... 132
71. Unlocking the robot................................................................................................................................ 133
72. Finger holes.............................................................................................................................................133
xi