Users Guide
Figure 58. Drive bay covers
Note: A full-height tape drive must be installed in the lowest bay of the module.
2. Align and slowly insert the new tape drive into the drive bay along the alignment rails ( 1 in Figure 59
on page 117) while the drive assembly is supported. The tape drive must be flush with the back panel
of the library.
Figure 59. Alignment rails
3. Tighten the captive thumbscrews ( 1 in Figure 60 on page 118) with your ī³ngers until the tape drive is
secure.
Chapter 6. Upgrading and servicing
117