Users Guide

3. Remove the left magazine to provide clear access to the spooling mechanism.
4. Follow the steps in “Removing the accessor and spooling mechanism from the Base Module” on page
132 to remove the accessor, disconnect the spooling cable, and place it in the park position.
5. Push down on the lever on the top of the spooling mechanism ( 1 ) and slide about 10 mm towards the
center ( 2 ) to unlock the mechanism.
Figure 79. Unlocking the spooling mechanism
Note: Make sure that the spooling mechanism is unlocked before you try to pull it out. When the
mechanism is unlocked, the cutout behind the mechanism is covered, and the mechanism cannot slide
any further to the center.
Chapter 6. Upgrading and servicing
139