Users Guide

Figure 34. Lifting the cover and locking it

Installing modules in a rack

Rackmount installation procedure.

Modules are easy to install in racks that are compliant to the EIA 310A Standard, when at least 1 meter

deep. You need a #2 Phillips screwdriver for this process.

Note: Install modules from the bottom to the top. Refer to “Structure and supported library

congurations” on page 2 for the correct conguration of Base and Expansion Modules.

To locate the rail locations when multiple modules are installed.

1. Locate the bottom of the lowest full U where the lowest module is installed.

2. Continue identifying the locations for any additional module 3U higher.

To install the rails into the rack, starting from the lowest rack location.

a. Locate the four universal rack connectors, four Philips screws, and two rackmount rails (LH and

RH).

Note: The universal rack connectors have two sides, for round hole and square hole racks. The

square-hole side might be painted.

Figure 35. Universal rack connector

Chapter 3. Installing