Install Guide
Table Of Contents
- MXG610s Fibre Channel Switch Module Installation Guide May 2021
- Contents
- About this guide
- Switch module overview
- Installation preparation
- Switch module installation overview
- Transceiver and cable installation
- Switch module monitoring
- Initial setup and verification
- Technical specifications
- Regulatory statements
- Caution and danger notices
- Dell EMC support
Table 8. Default switch module settings (continued)
Setting Description
Subnet mask After factory restore defaults: 255.255.255.0
Gateway IP address After factory restore defaults: 192.168.0.1
Username admin
Password admin
Table 9. Default access gateway mode settings
Setting Description
N-ports: automatic failover Enabled on all ports
N-ports: automatic failback Enabled on all ports
APC policy default Disabled
Group policy default Enabled
ADS policy default Disabled
Preferred secondary failover None specified
Table 10. Default access gateway mode port mapping
Internal port: F_port / Server port External port: N_port / Fabric port HBA Mezzanine Port
1 0 Lane 0 of Server Sled 1
2 17 Lane 0 of Server Sled 2
3 18 Lane 0 of Server Sled 3
4 19 Lane 0 of Server Sled 4
5 20 Lane 0 of Server Sled 5
6 21 Lane 0 of Server Sled 6
7 22 Lane 0 of Server Sled 7
8 23 Lane 0 of Server Sled 8
9 24 Lane 1 of Server Sled 1
10 25 Lane 1 of Server Sled 2
11 26 Lane 1 of Server Sled 3
12 27 Lane 1 of Server Sled 4
13 28 Lane 1 of Server Sled 5
14 29 Lane 1 of Server Sled 6
15 30 Lane 1 of Server Sled 7
16 31 Lane 1 of Server Sled 8
Table 11. Management port
System components Description
Console port Micro-USB; external front panel
Ethernet port Internal backplane
Technical specifications 31