Install Guide
Table Of Contents
- MXG610s Fibre Channel Switch Module Installation Guide May 2021
- Contents
- About this guide
- Switch module overview
- Installation preparation
- Switch module installation overview
- Transceiver and cable installation
- Switch module monitoring
- Initial setup and verification
- Technical specifications
- Regulatory statements
- Caution and danger notices
- Dell EMC support
About this guide
This guide provides site preparation recommendations, step-by-step procedures for rack mounting and desk mounting, inserting
modules, and connecting to a power source.
CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this
equipment.
NOTE: Only trained and qualified personnel can install this equipment. Read this guide before you install and power up this
equipment. This equipment contains two power cords. Disconnect both power cords before servicing.
NOTE: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
Figure 1. Class 1 laser product tag
NOTE: When no cable is connected, visible and invisible laser radiation may be emitted from the aperture of the optical
transceiver ports. Avoid exposure to laser radiation and do not stare into open apertures.
Topics:
• Supported hardware and software
• Document conventions
Supported hardware and software
This document is applicable for the following Fibre Channel (FC) switch modules:
Table 1. FC switch modules
Blade Server FC switch
module
Mini-Mezz HBAs Supported Dell EMC
chassis
Required OS version
Dell EMC MXG610s FC switch
Emulex LPm31002-D
Emulex LPm32002-D
QLogic QME2692-DEL
QLogic QME2742-DEL
Dell EMC PowerEdge
MX7000
Brocade Fabric OS 8.1.0_Inx
Brocade Fabric OS 9.0.1a
The following table lists the models of this switch module supported and available for use with the Dell EMC PowerEdge
MX7000 chassis:
1
About this guide 5