Setup Guide

MXG610s Setup Guide

Topics:

• Blade server preparation

• Switch module installation

• Serial connection

• Static IP addresses

• Optical transceivers and cabling installation

• Port-side LEDs

• Additional country-specic IEEE notices

Blade server preparation

Before you insert the switch module in the blade server chassis, meet the following

conditions:

• The blade server is powered up.

• The blade server chassis meets all its specic power requirements.

• The I/O module bay C1 or C2 is empty and ready to receive the switch module.

• If you are replacing an existing switch module, to maintain the proper cooling level in the

chassis, insert the replacement switch module within one minute.

Switch module installation

Insert the switch modules in the blade server chassis slots and check that the modules are

functioning properly.

MXG610s Setup Guide 5