Users Guide

Usage information To remove the conguration from an Ethernet or Fibre Channel interface and reset the interface to its default
settings, use the default interface command. By default:
• An Ethernet interface is enabled using the no shutdown command; a Fibre Channel interface is disabled
using the
shutdown command.
• An Ethernet interface is assigned to the default VLAN.
The default interface command removes all software settings and all L3, VLAN, and port-channel
congurations on a physical interface. You must manually remove congured links to the interface from other
software features; for example, if you congure an Ethernet interface as a discovery interface in a VLT domain.
Enter multiple interfaces in a comma-separated string or a port range using the default interface range
command.
There is no undo for this command. The no version of the command has no eect.
Example (Ethernet)
OS10# show running-configuration interface ethernet 1/1/15
!
interface ethernet1/1/15
no shutdown
no switchport
ip address 101.1.2.2/30
ipv6 address 2101:100:2:1::2/64
ipv6 ospf 65535 area 0.0.0.0
ipv6 ospf cost 10
ip ospf 65535 area 0.0.0.0
ip ospf cost 10
OS10# configure terminal
OS10(config)# default interface ethernet 1/1/15
Proceed to cleanup the interface config? [confirm yes/no]:yes
Mar 5 22:00:48 OS10 dn_l3_core_services[590]: Node.1-Unit.1:PRI:notice
[os10:trap], %Dell EMC (OS10) %log-notice:IP_ADDRESS_DEL: IP Address delete is
successful. IP 101.1.2.2/30 deleted successfully
Mar 5 22:00:48 OS10 dn_l3_core_services[590]: Node.1-Unit.1:PRI:notice
[os10:trap], %Dell EMC (OS10) %log-notice:IP_ADDRESS_DEL: IP Address delete is
successful. IP 2101:100:2:1::2/64 deleted successfully
OS10(config)# end
OS10# show running-configuration interface ethernet 1/1/15
!
interface ethernet1/1/15
no shutdown
switchport access vlan 1
Example (Fibre
channel)
OS10# show running-configuration interface fibrechannel 1/1/1
!
interface fibrechannel1/1/1
no shutdown
description fc-port
OS10(config)# default interface fibrechannel 1/1/1
Proceed to cleanup the interface config? [confirm yes/no]:y
!
OS10 # show running-configuration interface fibrechannel 1/1/1
interface fibrechannel1/1/1
shutdown
Example (Range of
interfaces)
OS10(config)# interface range ethernet 1/1/1-1/1/4
OS10(conf-range-eth1/1/1-1/1/4)# show configuration
!
interface ethernet1/1/1
no shutdown
Interfaces 111