Users Guide

Default VLAN 1
Command Mode CONFIGURATION
Usage Information FTP, TFTP, MAC ACLs, and SNMP operations are not supported — IP ACLs are supported on VLANs only. The no
version of this command deletes the interface.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)#
Supported Releases 10.2.0E or later
link-bundle-utilization
Congures link-bundle utilization.
Syntax
link-bundle-utilization trigger-threshold value
Parameters value — Enter the percentage of port-channel bandwidth that triggers trac monitoring on port-channel
members (0 to 100).
Default Disabled
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# link-bundle-utilization trigger-threshold 10
Supported Releases 10.2.0E or later
mode
Congures a front-panel unied port group to operate in Fibre Channel or Ethernet mode, or a QSFP28-DD or QSFP28 port group to
operate in Ethernet mode, with the specied speed on activated interfaces.
Syntax
mode {Eth {100g-2x | 100g-1x | 50g-2x | 40g-2x | 40g-1x | 25g-8x [fabric-
expander-mode] | 25g-4x | 10g-8x | 10g-4x} | FC {32g-4x | 32g-2x | 32g-1x |
16g-4x}}
Parameters
• mode Eth — Congure a port group in Ethernet mode and set the speed to:
– 100g-2x — Split a QSFP28-DD port into two 100GE interfaces.
– 100g-1x — Reset a QSFP28 port group to 100GE mode.
– 50g-2x — Split a QSFP28 port into two 50GE interfaces.
– 40g-2x — Split a port group into two 40GE interfaces.
– 40g-1x — Set a port group to 40G mode for use with a QSFP+ 40GE transceiver.
– 25g-8x fabric-expander-mode — Split a QSFP28-DD port into eight 25GE interfaces for
connection to a Fabric Expander.
– 25g-8x — Split a port group into eight 25GE interfaces.
– 25g-4x — Split a port group into four 25GE interfaces.
– 10g-8x — Split a port group into eight 10GE interfaces.
– 10g-4x — Split a port group into four 10GE interfaces.
• mode FC — Congure a port group in Fibre Channel mode and set the speed to:
118 Interfaces