Users Guide
Usage Information By default, MST protocol assigns system MAC as the region name. Two MST devices within the same region must
share the same region name, including matching case.
Example
OS10(conf-mst)# name my-mst-region
Supported Releases 10.2.0E or later
revision
Congures a revision number for the MSTP conguration.
Syntax
revision number
Parameters number — Enter a revision number for the MSTP conguration (0 to 65535).
Default 0
Command Mode MULTIPLE-SPANNING-TREE
Usage Information To have a bridge in the same MST region as another, the default values for the revision number must match on all
Dell hardware devices. If there are non-Dell devices, ensure the revision number value matches on all the devices
(see Non-Dell Hardware).
Example
OS10(conf-mst)# revision 10
Supported Releases 10.2.0E or later
spanning-tree bpdulter
Enables or disables BPDU ltering on an interface.
Syntax
spanning-tree bpdufilter {enable | disable}
Parameters
• enable — Enables the BPDU ltering on an interface.
• disable — Disables the BPDU ltering on an interface.
Default Disabled
Command Mode INTERFACE
Usage Information Use the enable parameter to enable BPDU ltering.
Example
OS10(conf-if-eth1/1/4)# spanning-tree bpdufilter enable
Supported Releases 10.2.0E or later
spanning-tree bpduguard
Enables or disables BPDU guard on an interface.
Syntax
spanning-tree bpduguard {enable | disable}
Parameters
• enable — Enables the BPDU guard lter on an interface.
• disable — Disables the BPDU guard lter on an interface.
220 Layer 2