Users Guide
source-ip | protocol | vlan-id | l4–destination-port | l4–source-port] | [mac-
selection destination-mac | source-mac | ethertype | vlan-id]}
Parameters
• ingress-port enable — Enables load-balancing on ingress ports.
• tcp-udp-selection — Enables the TCP UDP port for load-balancing conguration.
• ip-selection — Enables IPv4 key parameters to use in the hash computation.
• ipv6-selection — Enables IPV6 key parameters to use in hash computation.
• destination-ip — Enables the destination IP address in the hash calculation.
• source-ip — Enables the source IP address in the hash calculation.
• protocol — Enables the protocol information in the hash calculation.
• vlan-id — Enables the VLAN ID information in the hash calculation.
• l4-destination-port — Enables the L4 destination port information in the hash calculation.
• l4-source-port — Enables the L4 source port information in the hash calculation.
• mac-selection — Enables MAC load-balancing congurations.
• destination-mac— Enables the destination MAC information in hash the calculation.
• source-mac— Enables the source MAC information in the hash calculation.
• ethertype — Enables the Ethernet type information in the hash calculation.
Default
• ip-selelection—source—ip dest-ip vlan-id l4–source-port l4–dest-port ipv4
protocol
• ipv6-selection—source—ipv6 dest-ipv6 vlan—id l4–source-port l4–dest-port ipv6
protocol
•
mac-selection—source—mac destination—mac vlan-id ethertype
• tcp-udp-selection—l4–source-port l4–dest-port
Command Mode CONFIGURATION
Usage Information
• IPv4– selection: source-ip destination-ip protocol vlan-id l4-destination-port l4-
source-port
• IPv6 destination address: source-ip destination-ip protocol vlan-id l4-destination-
port l4-source-port
•
MAC parameters: source-mac destination-mac ethertype vlan-id
• TCP/UDP parameters: l4-destination-port l4-source-port
The no version of this command resets the value to the default.
Example (Ingress)
OS10(config)# load-balancing ingress-port enable
Example (IP
Selection)
OS10(config)# load-balancing ip-selection destination-ip source-ip
Supported Releases 10.2.0E or later
show hash-algorithm
Displays the hash-algorithm information.
Syntax
show hash-algorithm
Parameters None
Layer 3 325