Users Guide

Usage Information Use this command to create a shortcut to long commands along with arguments. Use the numbers 1 to 9 along with
the $ to provide input parameters. The no version of this command deletes an alias.
Example
OS10# alias showint "show interface $*"
OS10# showint status
---------------------------------------------------------------------------------
Port Description Status Speed Duplex Mode Vlan Tagged-Vlans
---------------------------------------------------------------------------------
Eth 1/1/1 up 40G A 1 -
Eth 1/1/2 up 40G A 1 -
Eth 1/1/3 up 40G A 1 -
Eth 1/1/4 up 40G A 1 -
Eth 1/1/5 up 40G A 1 -
Eth 1/1/6 up 40G A 1 -
Eth 1/1/7 up 40G A 1 -
Eth 1/1/8 up 40G A 1 -
Eth 1/1/9 up 40G A 1 -
Eth 1/1/10 up 40G A 1 -
Eth 1/1/11 up 40G A 1 -
Eth 1/1/12 up 40G A 1 -
Eth 1/1/13 up 40G A 1 -
Eth 1/1/14 up 40G A 1 -
Eth 1/1/15 up 40G A 1 -
Eth 1/1/16 up 40G A 1 -
Eth 1/1/17 up 40G A 1 -
Eth 1/1/18 up 40G A 1 -
Eth 1/1/19 up 40G A 1 -
Eth 1/1/20 up 40G A 1 -
Eth 1/1/21 up 40G A 1 -
Eth 1/1/22 up 40G A 1 -
Eth 1/1/23 up 40G A 1 -
Eth 1/1/24 up 40G A 1 -
Eth 1/1/25 up 40G A 1 -
Eth 1/1/26 up 40G A 1 -
Eth 1/1/27 up 40G A 1 -
Eth 1/1/28 up 40G A 1 -
Eth 1/1/29 up 40G A 1 -
Eth 1/1/30 up 40G A 1 -
Eth 1/1/31 up 40G A 1 -
Eth 1/1/32 up 40G A 1 -
--------------------------------------------------------------------------------
OS10# configure terminal
OS10(config)# alias goint "interface ethernet $1"
OS10(config)# goint 1/1/1
OS10(conf-if-eth1/1/1)#
Supported Releases
10.3.0E or later
alias (multi-line)
Creates a mulit-line command alias.
Syntax
alias alias-name
Parameters alias-name — Enter the name of the alias (up to 20 characters).
Default Not congured
Command Mode CONFIGURATION
Getting Started 47