Users Guide

● If you configure a prefix with valid or preferred lifetime values, the ipv6 nd prefix default no
autoconfig command does not apply the default prefix values.
● On-link determination is used to forward IPv6 packets to a destination IPv6 address.
Examples
Enable router advertisements
OS10(conf-if-eth1/1/1)# ipv6 address 2001:0db8:2000::1/64
OS10(conf-if-eth1/1/1)# ipv6 nd send-ra
Change default settings for interface subnet prefixes
OS10(conf-if-eth1/1/1)# ipv6 nd prefix default lifetime infinite infinite
Disable advertising an interface subnet prefix
OS10(conf-if-eth1/1/1)# ipv6 nd prefix 2001:0db8:2000::/64 no-advertise
Advertise prefix for which there is no interface address
OS10(conf-if-eth1/1/1)# ipv6 nd prefix 2001:0db8:3000::/64 no-autoconfig
Supported
Releases
10.4.0E(R1) or later
ipv6 nd ra-lifetime
Sets the lifetime of the default router in RA messages.
Syntax
ipv6 nd ra-lifetime seconds
Parameters
● ra-lifetime seconds — Enter a lifetime value in milliseconds, from 0 to 9000 milliseconds.
Defaults Three times the max-ra-interval value
Command Mode INTERFACE
Usage
Information
The no version of this command restores the default lifetime value. 0 indicates that this router is not
used as the default router.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd max-ra-interval 300
Supported
Releases
10.4.0E(R1) or later
ipv6 nd reachable-time
Sets the advertised time the router sees a neighbor to be up after it receives a reachability confirmation.
Syntax
ipv6 nd reachable-time milliseconds
Parameters
● reachable-time milliseconds — Enter the reachable time in milliseconds, from 0 to 3600000.
Defaults 0
Command Mode INTERFACE
Usage
Information
The no version of this command restores the default reachable time. 0 indicates that no reachable time is
sent in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd reachable-time 1000
Layer 3 677