API Guide

The following is an example of configuring privilege levels and assigning them to a user:
OS10(config)# privilege exec priv-lvl 12 "show version"
OS10(config)# privilege exec priv-lvl 12 "configure terminal"
OS10(config)# privilege configure priv-lvl 12 "interface ethernet"
OS10(config)# privilege interface priv-lvl 12 "ip address"
OS10(config)# username delluser password $6$Yij02Phe2n6whp7b$ladskj0HowijIlkajg981 role
secadmin priv-lvl 12
The following example shows the privilege level of the current user:
OS10# show privilege
Current privilege level is 15.
The following example displays the privilege levels of all users who are logged into OS10:
OS10# show users
Index Line User Role Application Idle Login-Time Location Privilege
----- ------ ----- ----- ----------- ---- ----------- -------- ---------
1 pts/0 admin sysadmin bash >24h 2018-09-08 T06:51:37Z 10.14.1.91 [ssh] 15
2 pts/1 netad netadmin bash >24h 2018-09-08 T06:54:33Z 10.14.1.91 [ssh] 10
Configure enable password for a privilege level
After you configure privilege levels for users, assign commands to each level and an enable password to access each level:
1. Configure a privilege level and assign commands to it in CONFIGURATION mode.
privilege mode priv-lvl privilege-level command-string
● mode — Enter the privilege mode used to access CLI modes:
○ exec — Accesses EXEC mode.
○ configure — Accesses class-map, DHCP, logging, monitor, openflow, policy-map, QOS, support-assist, telemetry,
CoS, Tmap, UFD, VLT, VN, VRF, WRED, and alias modes.
○ interface — Accesses Ethernet, fibre-channel, loopback, management, null, port-group, lag, breakout, range,
port-channel, and VLAN modes.
○ route-map — Accesses route-map mode.
○ router — Accesses router-bgp and router-ospf modes.
○ line — Accesses line-vty mode.
● priv-lvl privilege-level — Enter the number of a privilege level, from 2 to 14.
● command-string — Enter the command supported at the privilege level.
For sysadmin, netadmin, and secadmin roles, you cannot configure a privilege level less than 2 .
2. Configure an enable password for each privilege level in CONFIGURATION mode.
enable password encryption-type password-string priv-lvl privilege-level
● encryption-type — Enter an encryption type for the password entry:
○ 0 — Use plain text with no password encryption.
○ sha-256 — Encrypt the password using the SHA-256 algorithm.
○ sha-512 — Encrypt the password using the SHA-512 algorithm.
● priv-lvl privilege-level — Enter a privilege level, from 1 to 15.
OS10(config)# privilege exec priv-lvl 3 "show version"
OS10(config)# enable password 0 P@$$w0Rd priv-lvl 3
OS10(config)# privilege exec priv-lvl 12 "configure terminal"
OS10(config)# privilege configure priv-lvl 12 route-map
OS10(config)# privilege route-map priv-lvl 12 "set local-preference"
OS10(config)# enable password sha-256 $5$2uThib1o$84p.tykjmz/w7j26ymoKBjrb7uepkUB priv-
lvl 12
Security
1017