API Guide

OS10 (config-openflow)# in-band-mgmt interface ethernet 1/1/1
OS10 (config-openflow)# no shutdown
Supported
Releases
10.4.1.0 or later
max-backoff
Configures the time interval, in seconds, that the logical switch instance waits after requesting a connection with the OpenFlow
controller.
Syntax
max-backoff interval
Parameters intervalEnter the amount of time, in seconds, that the logical switch instance waits after it
attempts to establish a connection with the OpenFlow controller, from 1 to 65,535.
Default 8 seconds
Command Mode OPENFLOW SWITCH CONFIGURATION
Usage
Information
If the interval time lapses, the logical switch instance re-attempts to establish a connection with the
OpenFlow controller.
Example
OS10 (config)# openflow
OS10 (config-openflow)# switch of-switch-1
OS10 (config-openflow-switch)# max-backoff 25
OS10 (config-openflow-switch)#
Supported
Releases
10.4.1.0 or later
mode openflow-only
Enables OpenFlow-only mode on the switch.
Syntax
mode openflow-only
Parameters None
Default None
Command Mode OPENFLOW CONFIGURATION
Usage
Information
Use this command to enable OpenFlow-only mode. This command reloads the switch and boots to
OpenFlow-only mode. This command deletes all L2 and L3 configurations. However, the system
management and AAA configurations are retained.
The no form of this command prompts you to reload the switch. If you enter yes, the switch deletes all
OpenFlow configurations, including the controller IP, port, certificates, and reloads, then returns to the
Normal mode.
NOTE: For a list of available commands when the switch is in the OpenFlow-only mode, see CLI
commands available in the OpenFlow-only mode.
Example
OS10 (config-openflow)# mode openflow-only
OS10 (config-openflow)#
Supported
Releases
10.4.1.0 or later
OpenFlow 1103