API Guide

● operator — (Optional) Enter a logical operator to match the packets on the specified port number.
The following options are available:
○ eq — Equal to
○ gt — Greater than
○ lt — Lesser than
○ neq — Not equal to
○ range — Range of ports, including the specified port numbers.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you use the count byte options, only bytes
increment. The no version of this command removes the filter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny udp any any capture session 1
Supported
Releases
10.2.0E or later
description
Configures an ACL description.
Syntax
description text
Parameters text — Enter the description text string. A maximum of 80 characters.
Default Disabled
Command Modes IPV4-ACL, IPV6-ACL, MAC-ACL
Usage
Information
The no version of this command deletes the ACL description.
Example
OS10(conf-ipv4-acl)# description ipacltest
Supported
Releases
10.2.0E or later
ip access-group
Configures an IPv4 access group.
Syntax
ip access-group access-list-name {in | out}
Parameters
● access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
● in — Apply the ACL to incoming traffic.
● out — Apply the ACL to outgoing traffic.
Default Not configured
Command Mode
INTERFACE
CONTROL-PLANE
Usage
Information
Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are
only applied on the ingress traffic. By default, the control-plane ACL is applied to the front-panel ports as
well as the management port.The no version of this command deletes the IPv4 ACL configuration.
1136 Access Control Lists