API Guide

Command Mode IPV4-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter, or use the no seq sequence-number
command if you know the filter’s sequence number.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# seq 10 permit ip any any capture session 1 log
Supported
Releases
10.2.0E or later
seq permit (IPv6)
Assigns a sequence number to permit IPv6 packets, while creating a filter.
Syntax
seq sequence-number permit protocol-number [A::B | A::B/x | any | host
ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | count |
dscp value | fragment | log]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● protocol-number — (Optional) Enter the protocol number, from 0 to 255.
● A::B — Enter the IPv6 address in hexadecimal format separated by colons.
● A::B/x — Enter the number of bits that must match the IPv6 address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
● host ipv6-address — (Optional) Enter the IPv6 address to be used as the host address.
● capture — (Optional) Enter to capture packets the filter processes.
● count — (Optional) Enter to count packets the filter processes.
● byte — (Optional) Enter to count bytes the filter processes.
● dscp value — (Optional) Enter the DSCP value to permit a packet, from 0 to 63.
● fragment — (Optional) Enter to use ACLs to control packet fragments.
● log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter, or use the no seq sequence-number
command if you know the filter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 10 permit ipv6 any any capture session 1 log
Supported
Releases
10.2.0E or later
seq permit (MAC)
Assigns a sequence number to permit MAC addresses while creating a filter.
Syntax
seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any}
{nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture |
cos | count [byte] | vlan]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing, from 1 to 16777214.
Access Control Lists 1161