API Guide

Unit State Temperature Voltage
--------------------------------------------
1 up 42
--------------------------------------------
Thermal sensors
Unit Sensor-Id Sensor-name Temperature
---------------------------------------------------------
1 1 T2 temp sensor 28
1 2 system-NIC temp sensor 25
1 3 Ambient temp sensor 24
1 4 NPU temp sensor 40
---------------------------------------------------------
Link-bundle monitoring
Monitoring link aggregation group (LAG) bundles allows the traffic distribution amounts in a link to look for unfair distribution at
any given time. A threshold of 60% is an acceptable amount of traffic on a member link.
Links are monitored in 15-second intervals for three consecutive instances. Any deviation within that time sends syslog and an
alarm event generates. When the deviation clears, another syslog sends and a clear alarm event generates.
Link-bundle utilization calculates the total bandwidth of all links divided by the total bytes-per-second of all links. If you enable
monitoring, the utilization calculation performs when the utilization of the link-bundle (not a link within a bundle) exceeds 60%.
Configure Threshold level for link-bundle monitoring
OS10(config)# link-bundle-trigger-threshold 10
View link-bundle monitoring threshold configuration
OS10(config)# do show running-configuration
link-bundle-trigger-threshold 10
!
...
Show link-bundle utilization
OS10(config)# do show link-bundle-utilization
Link-bundle trigger threshold - 10
Alarm commands
alarm acknowledge
Acknowledges an active alarm.
Syntax
alarm acknowledge sequence-number
Parameters
● sequence-number — Acknowledge the alarm corresponding to the sequence number.
Default Not configured
Command Mode EXEC
Usage
Information
Use the show alarm command to view all active alarms. Use active alarm sequence numbers to
acknowledge specific alarms.
Example
OS10# alarm acknowledge 1
Supported
Releases
10.4.3 or later
1440 Troubleshoot Dell EMC SmartFabric OS10