API Guide

logging enable
Enables system logging.
Syntax
logging enable
Parameters None
Default Enabled
Command Mode CONFIGURATION
Usage
Information
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S).
Also supported in SmartFabric mode starting in release 10.5.0.1.
The no version of this command disables all logging.
Example
OS10(config)# logging enable
Supported
Releases
10.2.0E or later
logging log-file
Disables, enables, or sets the minimum severity level for logging to the log file.
Syntax
logging log-file {disable | enable | severity}
Parameters severity — Set the minimum logging severity level:
● log-emerg — Set the system as unusable.
● log-alert — Set to immediate action is needed.
● log-crit — Set to critical conditions.
● log-err — Set to error conditions.
● log-warning — Set to warning conditions.
● log-notice — Set to normal but significant conditions, the default.
● log-info — Set to informational messages.
● log-debug — Set to debug messages.
Default Log-notice
Command Mode CONFIGURATION
Usage
Information
To reset the log-file severity to the default level, use the no logging log-file severity
command. The default severity level is log-notice.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S).
Also supported in SmartFabric mode starting in release 10.5.0.1.
Example
OS10(config)# logging log-file disable
Example (Enable)
OS10(config)# logging log-file enable
Example
(Severity)
OS10(config)# logging log-file severity log-notice
Supported
Releases
10.2.0E or later
1448 Troubleshoot Dell EMC SmartFabric OS10