API Guide

Telnet commands
ip telnet server enable
Enables Telnet TCP/IP connections to an OS10 switch.
Syntax
ip telnet server enable
Parameters None
Default Disabled
Command Mode CONFIGURATION
Usage
Information
By default, the Telnet server is disabled. When you enable the Telnet server, use the IP address
configured on the management or any front-panel port to connect to an OS10 switch. After you reload
the switch, the Telnet server configuration is maintained. To verify the Telnet server configuration, use
the show running-configuration command.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0(R3S).
Also supported in SmartFabric mode starting in release 10.5.0.
Example
OS10(config)# ip telnet server enable
Example
(disable)
OS10(config)# no ip telnet server enable
Supported
Releases
10.4.0E(R1) or later
ip telnet server vrf
Configures the Telnet server for the management or non-default VRF instance.
Syntax
ip telnet server vrf {management | vrf vrf-name}
Parameters
● management — Configures the management VRF used to reach the Telnet server.
● vrf vrf-name — Enter the keyword vrf followed by the name of the VRF to configure the non-
default VRF instance used to reach the Telnet server.
Default If the Telnet server is enabled, the Telnet server is reachable on the default VRF.
Command Mode CONFIGURATION
Usage
Information
By default, the Telnet server is disabled. To enable the Telnet server, use the telnet enable
command.
Example
OS10(config)# ip telnet server vrf management
OS10(config)# ip telnet server vrf vrf-blue
Supported
Releases
10.4.0E(R1) or later
Simple Network Management Protocol
Network management stations use simple network management protocol (SNMP) to retrieve and modify software
configurations for managed objects on an agent in network devices. A managed object is a datum of management information.
The SNMP agent in a managed device maintains the data for managed objects in management information bases (MIBs).
Managed objects are identified by their object identifiers (OIDs). A remote SNMP agent performs an SNMP walk on the OIDs
stored in MIBs on the local switch to view and retrieve information.
158
System management