API Guide

*10.0.0.1 11.0.0.2 10 u 2 64 1 0.578 -1.060 0.008
OS10# show ntp status vrf red
associd=0 status=0615 leap_none, sync_ntp, 1 event, clock_sync,
system peer: 10.0.0.1:123
system peer mode: client
leap indicator: 00
stratum: 11
log2 precision: -24
root delay: 0.991
root dispersion: 1015.099
reference ID: 10.0.0.1
reference time: dbc7b087.5d47aaa6 Sat, Nov 5 2016 1:12:39.364
system jitter: 0.000000
clock jitter: 0.462
clock wander: 0.003
broadcast delay: -50.000
symm. auth. delay: 0.000
OS10#
5. Verify that the NTP server (10.0.0.1) is connected to the NTP master (11.0.0.2) running in VRF Red.
OS10(config)# do show ntp associations vrf red
remote refid st t when poll reach delay offset jitter
==============================================================================
LOCAL(0) .LOCL. 8 l 111 64 2 0.000 0.000 0.000
*11.0.0.2 LOCAL(0) 9 u 43 64 3 0.441 0.026 0.047
OS10(config)# do show ntp status vrf red
associd=0 status=0615 leap_none, sync_ntp, 1 event, clock_sync,
system peer: 11.0.0.2:123
system peer mode: client
leap indicator: 00
stratum: 10
log2 precision: -24
root delay: 0.441
root dispersion: 950.580
reference ID: 11.0.0.2
reference time: dbc7b03e.733f51d7 Sat, Nov 5 2016 1:11:26.450
system jitter: 0.000000
clock jitter: 0.009
clock wander: 0.000
broadcast delay: -50.000
symm. auth. delay: 0.000
OS10(config)#
NTP commands
ntp authenticate
Enables authentication of NTP traffic between the device and the NTP time serving hosts.
Syntax
ntp authenticate
Parameters None
Default Not configured
Command Mode CONFIGURATION
Usage
Information
Configure an authentication key for NTP traffic using the ntp authentication-key command.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S).
Also supported in SmartFabric mode starting in release 10.5.0.1.
The no version of this command disables NTP authentication.
System management 199